Installation recommendations
Remember there are specific standards that have to be strictly followed regarding the safety rules of electrical
installation and automatic doors. As for the legal requirements and standards that must be adhered to,
please take notice of the following points to ensure maximum safety and reliability of your installation.
1. Before installing check the surrounding environment. Carefully evaluate any hazards which could be physical
damage (transiting vehicles, parts of trees falling, etc.), possible contact with persons, insects, leaves, flooding
hazards or any other exceptional events.
2. Check the main voltage numbers are the same as the numbers that are given on the rating plate in this manual.
3. Check and make sure there is suitable electrical protection against short circuits/power spikes and proper
earthing on the main supply.
Remember the unit has main voltage running through it (electrocution hazard, fire hazard).
4. Take care of the control unit, the parts may be subject to damage if the control unit is abused.
5. Make sure that you have all the necessary materials and that they are suitable for this kind of use.
6. Read all the instructions thoroughly and make sure they are understood before attempting to install the opener.
7. Before starting the installation carefully analyze all the risks relating to automating the door. Verify that the door
is automated in sound condition and that the mechanisms are in good working order. Observe the safety margins
and minimum distances.
8. Carefully evaluate the safety devices to be installed and the right place to install them, always install an
emergency stop device for power interruption to the opener if it is required.
9. Once the risks have been analyzed, install the opener and relative safety devices, emergency stop, and/or
photo beams.
Important note: As for additional safety rules, we strongly recommend the fitting of Photo beams on all
installations.
10. While installing the opener, strictly follow all the instructions given in the instruction manual. If some points or
procedures in this manual are not very clear do not install the unit until all doubts have been cleared up with our
technical department.
To Next Page
Loading...
Need help?
General
