Important safety recommendations
The new GDO is professionally designed under the newest design idea. The installation and setting of this GDO
are extremely easy. It has complete functions, giving the users a relaxed and happy installation experience.
Warning: It is very important to read this safety warning and follow all instructions before installing.
Or it may cause serious personal injury and/or property loss. Save these instructions.
1. This appliance should not be used by children or persons with reduced physical, sensory or mental capabilities
without supervision.
2. We strongly recommend installing photo beams to increase safety protection and psychological security.
3. Before installing the drive, remove any unnecessary ropes or chains and disable any equipment, such as locks
not needed for powered operation. Check that the door is in good mechanical condition, balanced and
opens and closes properly.
4. A-weighted emission sound pressure level of the drive LpA≤ 70 dB(A).
5. The operator must not be used for doors without a safety catch.
6. Install the actuating member for the manual release at a height of less than 1,8 m. If removable, the actuating
member should be stored in the direct vicinity of the door.
7. Install any fixed control at a height of at least 1,5 m and within sight of the door but away from moving parts.
8. Wall switch or wall transmitter must be installed out of the reach of children.
9. Permanently fix the labels warning against entrapment in a prominent place or near any fixed controls.
10. Permanently fix the label concerning the manual release adjacent to its actuating member.
11. After installation, ensure that the mechanism is properly adjusted and that the drive reverses or the object can
be freed when the door contacts a 50 mm high object placed on the floor. Ensure that parts of the door do not
extend over public footpaths or roads – repeat the test monthly.
12. Refer to pages 4-8 for information on how to adjust the door and drive.
13. Connect the GDO to the 220V AC circuit and fix it to the required place by a professional
person.
WARNING: The drive shall be disconnected from its power source during cleaning, maintenance and when
replacing parts.
To Next Page
Loading...
Need help?
General
