DTS 1000 - Basic Function Setting

Basic function setting
1. Limit setting Opening & Closing force dynamically self-learning
Press and hold ‘K1’ until the LED displays figure ‘1’, like in Fig. 1, and
then adjust the open limit by pressing the ‘K3’ button. Fine-tuning with
‘K3’ or ‘K4’ buttons to determine the final open limit position then
pressing the ‘K1’ button, the display turns to ‘2’ automatically, like in
Fig. 2. Adjust the close limit by pressing the ‘K4’ button. Fine-tuning
with‘K3’ or ‘K4’buttons to determine the final close limit position then
pressing the ‘K1’button to confirm. The garage door opener will
operate a cycle automatically to remember the limit positions and the
opening & closing force.
2. Matching the receiver and transmitter
Press and hold ‘K2’ until the LED dot appears. (Fig. A)
Then press any button on the transmitter, and the dot will be off;
press the button again the dot will fast flash then the LED displays
‘u’ (Fig. B). After that, the transmitter will be available. It will be able
to control the opening, closing, and stopping of the garage door
opener.
Fig. A
Repeat step 2 to code a maximum of 20 transmitters onto the
garage door opener.
To master erase the receiver, press and hold ‘K2’ button, the LED
dot will flash, keep holding for approximately 8 seconds until the
LED display flashes a ‘C’. Release button. All transmitters are now
deleted.
Fig. B
9
Fig. 1
Fig. 2