Basic function introduction
1. Soft start, soft stop. Minimize start-up load on garage door opener and garage door
2. The door will stop during opening when contacting obstruction and will reverse at least 300mm during the
closing when contacting obstruction.
3. Opening & closing force dynamic self-learning. Can make sure the garage door driver will work steadily in
spite of changes in door resistance by seasonal variation.
4. Safety resistance adjustable with a wide range, sensitive and reliable.
5. Overloading force detecting, the door will reverse more than 150mm automatically when it is overloaded when
closing and will stop when it is overloaded when opening.
6. Low-voltage protection, the process will not perform any action of opening and closing when the voltage is too
low, door panel and controller won’t be damaged.
7. We adopt a rolling code transmitter, with billions of codes, which won’t be coincident code or pirated
code.
8. Auto-close function available.
9. Backup battery interface available, in case of power failure.
10. Wall switch interface available.
11. Photo beam interface available, the door will change to open when obstruction is detected while closing.
To Next Page
Loading...
Need help?
General
