DualLite LSN - 201.6 How to Change Operating Modes

25
User Keypad Actions Display Readout
[PRG] EnterControlCode
Setup Value
0 Enter Control Code
Setup Value 0
[ENT] PasswordRequired
Please enter 6-Digit user password
****** EnterControlCode
Setup Value 0
[ENT] Time14:00:00
 EnterTime(HH:MM:SS)__:__:__
093000[ENT] Time14:00:00
Enter Time(HH:MM:SS)09:30:00
IMPORTANT: The"TIME"(parameter0)and"DATE"(parameter10)mustbesetbyuserinorderforsystemto
operate properly.
201.5 How To Change Operating Modes
Therearefouravailableoperatingmodes:
1. Off = System Off
2. Line = AC Pass-Through
3. Auto = Standby Operation
4. On =InverterOn(EmergencyBatteryOperation)
The LSN inverter system will select the appropriate operating mode automatically upon start-up.
NOTE: Changing the operating mode may prevent the LSN system from operating during a power failure.
To change the system operating mode to Inverter Mode,followthesesteps:
1. Press [PRG]
2. Enter the parameter number “150”
3.Entertheuserpassword(ifnotalreadyactive)
4. Press [ENT]
5.Enterthedesiredoperatingmodeidentierandpress[ENT]
User Keypad Actions Display Readout
[PRG] Enter Control Code
setup value
150 Enter Control Code
setup value 150
[ENT] PasswordRequired
Please enter 6-digit user password
****** Enter Control Code
setup value 150
[ENT] User Inverter Mode Control Menu
 Off(1)Line(2)AUTO(3)On(4)
4 [ENT] Inverter Line Command Sent
 Off(1)Line(2)AUTO(3)On(4)