DualLite LSN - Page 30

30
Battery Voltage Log (Hot Key # 155)
An hourly log of the systems total battery voltage and the charging current. Retains the last 48 entries.
08120013:00BatV108.1VChgI0.1A
08120012:00BatV108.1VChgI0.1A
08120011:00BatV108.1VChgI0.1A
Battery Discharge Voltage Log (Hot Key # 156)
Logs the total battery voltage, at 5-minute intervals, while system is in inverter mode. Also displays the duration of the
power failure and the system's output VA. This type of information is very useful in determining battery performance.
Retains the last 40 entries.
08120011:480H9M102.4V231VA
08120011:430H5M101.5V237VA
08120011:380H0M107.2V225VA
Theaboveshowsthepowerfailureoccurredat11:38,initialbatteryvoltagewas107.2volts,theoutputloadwas225
VA. The power failure lasted 9 minutes, a battery voltage was taken at the 5-minute mark, and ending voltage after
the 9 minutes was 102.4 volts.
Power Log (Hot Key # 157)
Continuouslymonitorstheconnectedloadtotalpowerconsumption(inVA)andrecordsareadingeveryminute.
Retains the last 30 entries.
08120013:33:52223VA-min
08120013:32:52223VA-min
08120013:31:52223VA-min
Peak Value Report (Hot Key # 158)
Records peak system parameter readings for AC input voltage, AC output voltage, AC output current, battery voltage
and output VA.
ACVinobservedmax:119min:115
ACVoutobservedmax:119min:115
ACIoutobservedmax:5min:5
VAobservedmax:690.2min:646.4
BatteryV observedmax:114.5min:103.2
Diagnostic Status Report (Hot Key # 161)
Continuously monitors and logs internal microprocessor communication status. The information contained in this log
is to be used by factory trained technicians only.
Alarm Log (Hot Key # 25)
Logsthelast25systemalarms,thetypeofalarm,on/offtimesandtheirduration.Thesystem'salarmswillbe
covered in more depth in Section 205. At this point, we will simply show you what the log looks like and how to read it.
08120015:29CLRCktBrkrTripALM
08120015:29ALMCktBrkrTrip
06210014:55CLRACVoutLoALM
062100 14:55ALMACVoutLo0101
Each entry shows which alarm was activated and when. It also shows when the alarm cleared. In cases such as line
4, when the alarm activated because of a reading was either too low or too high, the log will show what the reading
was and where the trip point is set. In this example, the system detected a low AC output, it measured 0 volts - trip
point was set at 101 volts.