Clock setup
This function is used to set the clock time.
To set the clock, access the "SET" page in the menu.
SETTING THE TIME
Holding button (1, Fig. 9) pressed in position B " "
for 3 seconds in this menu page gives access to the
setup mode.
When accessing this function, the message "AM" will
flash; if button (1, Fig. 9) is pressed in position B
" " the message "PM" flashes; press button
(1, Fig. 9) in position B "
" to return to the previous
step (if the current time is 00:00, 12:00 will be
displayed when switching from "AM" to "PM").
- Pressing button (1, Fig. 9) in position A "
" gives
access to the hour setting mode; hours start to
flash. Each time the button is pressed in position
B "
", counter will increase in steps of 1 hour;
pressing and holding the button in position B
"
" counter will increase in steps of 1 hour per
second (the hour value does not flash while the
button is kept pressed).
- Pressing button (1, Fig. 9), in position A " " gives
access to the minute setting mode; minutes start
to flash. Each time the button is pressed in
position B " " counter will increase in steps of
1 minute; pressing and holding the button in
position B " ", the digit will increase in steps of
1 minute each second. If the button is held
depressed in position B " " for over 5
seconds,steps will increase by 1 minute every
100 ms (while the button is held depressed in
position B "
", seconds will not flash).
- Pressing the button in position A "
", exits setup
mode and the new time is displayed.
49
To Next Page
Loading...
