Ducati Monster 795 - Lap Timer and DDA Data Logger

Lap timer display (LAP)
This function lets you display lap times.
To enable this function, enter the menu and set the
"LAP" function to "On" by holding button (1, Fig. 9)
pressed in position B " " for 3 seconds.
The timer is started and stopped using the high-beam
flasher button FLASH (12, Fig. 4) on the LH switch.
When the LAP function is active, each time the
FLASH button is pressed, the display will show the
lap time for 10 seconds, before reverting to normal
mode.
30 laps max. can be recorded. If the memory is full,
each time the FLASH button is pressed, no more lap
times can be saved and the display will show the
flashing message "FULL" for 3 seconds until the
memory is reset.
MENU
Press B
for 3s
Press B
for 3s
Fig. 23
42