Light control
Low / High beam
This function allows you to reduce current
consumption from the battery, by managing headlight
switching-on and off.
At Key-On, the high beam and low beam lights are
OFF, only the parking lights are turned on.
Once the engine is started, the low beam is turned
on; with engine running the standard operation of the
lights is restored: it is possible to switch the high
beam on and off using button (3) in positions (A) and
(B). If engine is not started upon key-on, it is anyway
possible to switch high/low beams on by pushing
button (3) position (C) on LH switch.
If engine is not started within 60 seconds since
"manual ignition", the low and/or high beam lights are
turned OFF.
If the low beam and/or high beam was turned on
before starting the engine (with the procedure
described above), the headlight turns off
automatically when starting the engine and will turn
ON again when the engine has been completely
started.
Fig. 179
238
To Next Page
Loading...
