Ducati MULTISTRADA 1260 - Instrument Panel (Dashboard); Instrument Panel

Instrument panel (Dashboard)
Instrument panel
1) Display.
2) NEUTRAL LIGHT N (GREEN).
Comes on when in neutral position.
3) CRUISE CONTROL LIGHT (GREEN).
Comes on to indicate operation of the Cruise Control.
4) HIGH BEAM LIGHT
(BLUE).
It turns on to indicate that the high beam lights are on
and when the flasher is activated.
5) FUEL WARNING LIGHT
(AMBER YELLOW).
Comes on when fuel is low and there are about 4
litres of fuel left in the tank.
6) TURN INDICATOR LIGHTS
(GREEN).
Illuminates and flashes when the turn indicator is in
operation.
7) ENGINE OIL PRESSURE LIGHT
(RED).
Comes on when engine oil pressure is too low. It
must turn on at "KEY-ON", but must turn OFF a few
seconds after the engine has started. It may shortly
come on when the engine is hot, however, it should
go out as the engine revs up.
Important
If the ENGINE OIL light stays ON, stop the
engine or it may suffer severe damage.
8) DTC / DWC WARNING LIGHT (AMBER YELLOW)
This light indicates DTC/DWC system enabling/
disabling status.
- Light off: DTC/DWC enabled and functioning;
- Light ON flashing: DTC/DWC enabled, but with
degraded performance;
- Light steady ON: DTC/DWC disabled and/or not
functioning due to a fault in the control unit.
9) "ENGINE DIAGNOSIS - MIL" LIGHT
(AMBER
YELLOW).
It turns on in the case of "engine" errors that in some
cases will lock the engine.
10) ABS LIGHT
(AMBER YELLOW)
Indicates ABS status.
- Light off: ABS enabled and functioning;
- Light ON flashing: ABS in self-diagnosis and/or
functioning with degraded performance;
- Light steady ON: ABS disabled and/or not
functioning due to a fault in the ABS control unit.
31