Ducati MULTISTRADA 1260 - System Settings and Customization

Riding Mode
The Riding Mode can be selected from the
instrument panel. Four preset riding modes are
available: SPORT, TOURING, URBAN and ENDURO.
The selected and active riding mode is displayed on
the central lower side of the display.
Warning
Ducati recommends changing the Riding mode
when the motorcycle is stopped. If the riding mode is
changed while riding, be very careful (it is
recommended to change the Riding mode at a low
speed).
Every Riding Mode contains the following
parameters, set by Ducati or customised by the user
through the setting function pages:
- a specific level of intervention for the DTC
traction control (1, 2, 3, 4, 5, 6, 7, 8, OFF);
- a specific level of intervention for the DWC (1, 2,
3, 4, 5, 6, 7, 8, OFF);
- a specific ABS calibration (1, 2, 3, OFF);
- a specific DQS level (UP/DW, OFF)
- a specific engine power that will change throttle
behaviour (HIGH, MEDIUM, LOW).
- a specific calibration of DSS suspensions (setup
of front and rear suspensions and spring preload
setup for the rear shock absorber).
If an on/off or off/on change of the ABS system is
associated to the Riding Mode change, when the
selected riding mode is confirmed, the instrument
panel also starts procedure to enable/disable the ABS
explained in “ABS enabling/disabling” (page 116)
(only possible in the ENDURO Riding Mode).
A different standard screen layout (TRACK, FULL,
CITY and OFF ROAD) is associated to every riding
6
2538
LAP
LO
DQS
DTC 5
UP/DW
3
3
ABS
DWC
11
SPORT
109876
5
2
3
4
1
10:22
P.M.
RPM x 1000
GEAR
Km
Km/h
°C
TOT
299
260
MENU
13.5
Km/l
Km
SETTING
RANGE
CONS
AVG1
Fig. 21
63