3
1. RX808-LCD
RX808-LCD is an high performance receiver and full of functions, designed for professional use.
This is a radio receiver with 80 radio zones combined to 8 relay outputs (groups of 10 radio zones for each output).
Each radio zone hosts one detector.
When RX808-LCD receives the alarm radio code from a zone, it activates the combined relay output (N.C. type). Each radio sensor is completely
recognized by receiver (included opened/closed door in compatible sensors).
The alarm relay outputs (NC1-C1, …, NC8-C8) can be connected to wired zone inputs of a control panel to expand the alarm system with
wireless detectors, to activate an acoustic or light warning, or to start phone call via PSTN or GSM diallers.
RX808-LCD can store up to 9 remote controls. It is possible to:
Arm, partial arm and disarm (wired connection) the control panel
Arm the receiver in TOTAL (all the outputs enabled) or PARTIAL (only outputs 1 ÷ 6 enabled) mode
The receiver can work as MASTER or SLAVE of the alarm system to which is connected:
MASTER: RX808-LCD is enabled (TOTAL and PARTIAL arming) and disabled (DISARMED) using the remote controls. Connect the
terminals COM/NC/NA to the wired arming input of the control panel, the alarm system is armed and disarmed with the receiver.
On display is shown the status and – during the armed status – the alarms from radio zones are logged
SLAVE: RX808-LCD receives the armed (TOTAL, no partials) and disarmed status of control panel through wired connection (input
RST, the status is shown on display). During armed status the alarms from radio zones are logged
RX808 shows on display:
Different arming status (TOTAL, PARTIAL and DISARMED) of receiver and/or control panel
Alarm memory of radio zones with events log
Battery status of radio zones
Missed supervision of radio zones
RX808-LCD has alarm relay outputs for radio zones (NC1-C1, …, NC8-C8), and other outputs for:
ARMING/DISARMING (COM-NC-NA): output driven by remote controls, for connection to arming/disarming input of the control
panel
TAMPER (NCT-CT): to monitor the cover tampering or tamper alarm from radio zones
PROGRAMMABLE OUTPUT (P): programmable output for PARTIAL ARMING or SUPERVISION signalling
LOW BATTERY (LWB): to alert the low battery status of radio zones or radio-blinding
To Next Page
Loading...