Following screen appears:
(3) After finish the setting, press , it beeps pi-pi-pi three
times, repress to store the program, the flashing cursor
will be back to the first cut position, the screen will change to:
Use Addition (
+) Program
Turn on the power to the cutter, press wait until the back
gauge moves back and recalibrates the position, the following
screen appears, you can operate the Mark VII.
Select an empty program number from 1-500 (say 7), press and
cuts memory screen appears.
Press and new screen appears
~ 27 ~
~ 28 ~
26.000
0 0
0.000
26.000
3 4
18.000
12.000
6.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
26.000
3 1
18.000
12.000
6.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
26.000
7 1
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
18.000
12.000
6.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
18.000
12.000
6.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
To Next Page
Loading...
