Duplo 660P User Manual

How to use Step and Repeat Program
(even parts cutting for name card & label etc.)
Turn on the power to the cutter, press wait until the back
gauge moves back and recalibrates the position, the following
screen appears, you can operate the Mark VII.
Press the space where the arrow is, cuts memory screen will appear,
press the number of the program you wish to set up, then press the
when finish.
After choose the program number, press the flashing cursor cuts
memory screen appears, then you can start to enter the sizes of
each cut.
If the first cut is at 18.000 and you would like to divide it into 3,000
label for 5 times, please do as follows:
(I) Make the first cut say 18.000.
Press .
~39~ ~ 40 ~
26.000
0 0
0.000
26.000
0 0
0.000
9
26.000
9 1
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
26.000
9 1
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
18
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000

Duplo 660P Specifications

General

Brand	Duplo
Model	660P
Category	Paper Cutters
Language	English