Duplo 660P User Manual

(IV) After finish the setting, press , it beeps pi-pi-pi three
times, repress at once and it will beep 3 times to store the
program, the flashing cursor will be back to the first cut position,
and screen change to:
If you want to get into auto cut, press , backgauge will move
to the 1
st
cut position and the following screen appears:
Place the paper and make the first cut, when completing the cut,
back gauge will move to the second cut position.
Adjust the paper for the 2
nd
cut and make a cut, back gauge moves
to the 3
rd
cut position.
Adjust the paper for the 3
rd
cut and make the cut, back gauge will
then “push-out” your stack automatically. Then it moves to the first
cut position and readies itself for the next cut cycle.
After finish all cuts, press to remove backgauge automatic
movement, AUTO will disappear on the screen, and new screen
appears:
In Auto mode, if the present cut it not out through, you can adjust the
knife depth, press , backgauge will move back to the last cut
position, redo a cut after make knife depth adjustment, you can
repeat its movement (this is limited to the cut which is just used).
~37 ~
~ 38 ~
26.000
8 1
16.000
15.000
11.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
16.000
8 1
16.000
15.000
11.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
16.000
8 1
16.000
15.000
11.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
16.000
15.000
11.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
16.000
15.000
11.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
16.000
15.000
11.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000

Duplo 660P Specifications

General

Brand	Duplo
Model	660P
Category	Paper Cutters
Language	English