22
4. BINDING
4-6. Setting the Clearance Adjusting Plate
• When there are only a few sheets of paper
or when saddle-stapling and folding thin
paper, the position of the stapling and
folding may deviate.
In this case, decrease the clearance using
the clearance adjusting plate.
• When side-stapling or corner-stapling
paper, set the clearance widely.
<Narrow clearance>
<Wide clearance>
4-7. Selecting the Ball Unit Ball
• At manufacturer factory, a plastic ball will be
set. But in case the stapling position shifts or
paper jams when folding the paper after
stapling, change the plastic ball to the steel
ball.
Ball unit
Steel ball
To Next Page
Loading...
