48
6. SETTING THE AUTOMATIC MODE
Press the preset key on the control panel
of the DC-10. Test operations will start.
One set from the DC-10 is ejected to the
side-stapling paper receiving tray.
Follow the DC-10 instruction manual and
check the number, etc. of set of paper.
Paper stapling and folding operations are not
performed during test operations.
7
If the guide need not be adjusted finely,
proceed onto the following step 10.
• If the guide need be adjusted finely, refer to “4-8.
Raising Binding Accuracy”.
8 Set 1 set on the DC-10, press the start/
stop key.
Check the binding condition.
9
Set the number of sets to be bound on
the DC-10 and start binding operations.
NOTE : For details of the DC-10 operations, refer to
the “Instruction Manual for the DC-10”.
10
Check that the unit is set to the
automatic mode.
If the automatic mode is not set, set it by
pressing the auto/manual key.
Press until the buzzer stops (for about 2
seconds).
6
To Next Page
Loading...
