67
Problem Check
Correct
(6) Paper slips frequently.
(7) Paper jams frequently.
ó
Is the paper feed pressure too
high?
ò
Is the separator pressure too
low?
ô
Is the paper separator dirty?
ö
Are the sheets of paper sticking
to each other and cannot be
separated?
õ
Is paper outside the specified
sizes used?
ú
Has problems occurred inside
the unit?
ó
Is the paper feed pressure too
low?
ò
Is the separator pressure too
high?
ô
Is the paper feed ring dirty?
ö
Are the sheets of paper sticking
to each other and cannot be
separated.
õ
Is paper outside the specified
sizes used?
ú
Has problems occurred inside
the unit?
ó
Is the rubber roll dirty?
ò
Are paper shreds stuck inside
the paper conveyance
passage?
ô
The stacker roller position is not
correct if special folding is being
carried out.
ö
Is the paper curled?
õ
Due to static electricity.
(5) Double feed occurs frequently.
• Lower the paper feed pressure
gradually until the optimum
pressure is obtained.
• Raise the separator pressure
gradually until the optimum
pressure is obtained.
• Clean with neutral detergent or
alcohol.
• Loosen the paper properly and
load on the paper feed table.
• Do not use such a kind of paper
as they will cause problems.
• Contact your serviceman.
• Raise the separator pressure
gradually until the optimum
pressure is obtained.
• Lower the separator pressure
gradually until the optimum
pressure is obtained.
• Clean with neutral detergent or
alcohol.
• Loosen the paper properly and
load on the paper feed table.
• Do not use such paper as they
will cause problems.
• Contact your serviceman.
• Clean with neutral detergent or
alcohol.
• Check inside the unit and
remove any paper shreds.
• Re-set the position of the
stacker roller.
• Use an anti-static electricity
spray available on the market.
15. TROUBLE SHOOTING GUIDE
• Straighten the curl before use.
To Next Page
Loading...
Need help?
General