68
Problem Check
Correct
(8)When paper slips in the
vertical direction.
(9)When paper slips in the
horizontal direction.
(10) Paper jam at the rubber roll
when thick paper or cross
folded thick paper is folded
into two.
(11) Small paper is fed
continuously.
(Double-feed).
ó
Was the speed changed
halfway?
ò
Was the paper type (quality,
amount) changed halfway?
ó
Is the paper stacked
unevenly?
ò
Is there space between the
paper and guide?
ó
Is paper outside the specified
sizes used?
ò
Is the space inside the
internal paper conveyance
passage narrow?
ó
Is small paper outside the
specified sizes used?
ò
Is the paper feed pressure
too high?
• Adjust each folding stopper
finely.
• Use the original speed.
Adjust each folding stopper
finely again.
• Adjust each folding stopper
finely again.
• Stack the paper neatly on the
paper feed table.
• Adjust the guide firmly against
the paper.
• Rotate the slant correction
knob and correct the folding
slippage.
• Do not use such paper as they
will cause problems.
• Press the folding stopper
adjusting button of the second
folding plate twice and move
the folding stopper to the right.
• Decrease the paper feed
pressure by 1 from the
standard (0).
• Decrease the folding speed
until paper feeding stops.
15. TROUBLE SHOOTING GUIDE
• Do not use such a kind of
paper as they will cause
problems.
To Next Page
Loading...
Need help?
General