DuraLabel Bronco - Page 2

Graphic Products
®
, DuraLabel
®
, PathFinder
®
, Toro
®
, Bronco
®
, Lobo
®
, and Kodiak
®
are Registered Trademarks of Graphic Products, Inc.
© 2018 Graphic Products, Inc.
Minimum System Requirements
• Operating System: Windows XP Service Pack 2 (or later), Windows Vista,
Windows 7, or Windows 8 or 8.1. 64-bit (x64) system is supported.
• Memory: 128MB RAM
• Hard Drive Space: 100MB
• IT / Administrator Privileges for installation
Your label design software may have other requirements.
Supplies
DuraLabel supplies and DuraLabel
®
Bronco printers have been optimized for
compatibility and print quality. Use only DuraLabel supplies from Graphic Products with
your DuraLabel Bronco printer.
Copyright Information
This manual is copyrighted with all rights reserved. No portion of this manual may be
copied or reproduced by any means without the prior consent of Graphic Products, Inc.
While every precaution has been taken in preparation of this document, Graphic
Products, Inc. assumes no liability to any party for any loss or damage caused by errors
or omissions or by statements resulting from negligence, accident or any other cause.
Graphic Products, Inc. further assumes no liability for incidental or consequential
damages arising from the use of this document. Graphic Products, Inc. disclaims all
warranties of merchantability or fitness for a particular purpose.
Graphic Products, Inc. reserves the right to make changes without further notice to any
product or system herein to improve reliability, function or design.
Reproduction of this material, in part or whole, is strictly prohibited without the written
permission of Graphic Products, Inc.