GraphicProducts.com | 800.788.5572
8.4 US, Canadian and European EMC and EMI standards | 21
MAINTENANCE & TROUBLSHOOTING
8.2 5-Year DuraLabel Premium Vinyl Warranty
DuraLabel supplies are tested for durability under various conditions, including UV
exposure, moisture, heating and cooling cycles, abrasion, and chemical exposures.
Graphic Products warranties labels made from its Premium vinyl supplies for a period of
five (5) years.
Within five years of purchase and after proper application, Graphic Products will replace
labels made with DuraLabel Premium Vinyl which become unreadable or fail to maintain
adhesion with the labeled surface. In such instance, Graphic Products, Inc. will provide
a one-time replacement roll of the same supply.
8.3 FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To comply with the FCC RF exposure requirements, no change to the antenna or the device
is permitted. Any change to the antenna or the device could result in the device exceeding
the RF exposure requirements and void the user’s authority to operate the device.
8.4 US, Canadian and European EMC and EMI standards
This equipment has been tested and passed with the requirements relating to
electromagnetic compliance based on the standard EN 300 330-2 V1.5.1 (2010-02).
Per RSS-Gen, Section 8.4 this device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. This includes Industry
Canada (IC) certification number 9684A-DLBRONCO.
To Next Page
Loading...
