9
TC-12 TREE CHIPPER OPERATING INSTRUCTIONS
1.4 Shielding
Shields are installed for your protection. Keep them in place and replace damaged shields.
1.5 Safety Review Section
Before operating
Read and follow all instructions contained in:
• This TC-12 TREE CHIPPER operator’s manual
• Decals placed on the TC-12 TREE CHIPPER
• Check hydraulic oil level
6500339
WARNING: PINCH POINT STAY BACK
WARNING: CHECK FOR FIRES, CLEAN OFF DEBRIS,
SWITCH OFF BATTERY
NEVER LEAVE THIS MACHINE UNATTENDED UNTIL
ALL POTENTIAL FIRE DEBRIS IS REMOVED, NO FIRE
OR SMOLDERING EXISTS, AND THE BATTERY IS
SWITCHED OFF. REMOVE ALL FLAMMABLE DEBRIS
FROM ENGINE, SHIELDING, CONTROL PANEL, UNDER
MACHINE AND ANYWHERE MATERIAL IS COLLECTED.
DURATECH INDUSTRIES IS NOT RESPONSIBLE FOR
FIRES CAUSED BY HAZARDS LEFT TO SMOLDER OR
BURN, OR IMPROPER SHUTDOWN PROCEDURES.
6500425
To Next Page
Loading...