58
Problem Potential cause Solution
Hygiene flush
Hygiene flush does not work Actuator plate has been used
since the last hygiene flush
> Hygiene flush will occur at
the end of the next interval.
Hygiene flush is deactivated
> Activate the hygiene flush.
Hygiene flush occurs too often
or too seldom
Number of flushes is
incorrectly set
> Adjust the number of flush
packages.
Hygiene flush occurs at an
inappropriate time
The starting time is
incorrectly set
> Adjust the starting time.
Odour extraction
Odour extraction starts
automatically
Automatic mode is activated
> Factory settings.
> Adjust the mode if
necessary.
Odour extraction does not
start automatically
Manual mode is activated
> Adjust the mode.
Extraction power is not
satisfactory
Extraction power is not
optimally adjusted
> Adjust the extraction power.
Odour extraction stops
immediately after you leave
the toilet
Run-on time set to 0 min
> Active or extend the run-on
time.
Odour extraction does not stop
immediately after you leave
the toilet
Run-on time is set to a value
greater than 0 min
> Deactivate or reduce the
run-on time.
Night light function
Night light does not light up Night light is deactivated
> Activate the night light.
Ambient light is too bright
Night light lights up
continuously
Ambient light is too low
> Deactivate the night light.
Actuator plate is dirty or wet
> Clean or dry the actuator
plate.
en
To Next Page
Loading...
