DURAVIT Sensowash D-Code - Power supply

35
EN
3.3 Power supply
• Connect the SensoWash
®
D-Code only to an electrical socket with the specified
connected load. Use a residual-current protector.
• Make sure that the power cable and mains plug are not damaged.
• The power cable must not become jammed or pinched. Keep the cable away from
hot surfaces and sharp edges.
• Modifications to the mains plug or power cable may only be made by an expert.
• After installation, make sure that the mains plug is accessible to the user and do
not use an extension cable which is not properly earthed.
• Lay the cable so that it does not pose any risk of tripping.
• To pull the mains plug out of the electrical socket, always pull on the plug, not the
cable.
• Never touch the mains plug with wet hands.
• To disconnect the SensoWash
®
D-Code completely from the mains, unplug the
mains plug.
• If despite this the power cable or mains plug still become damaged, do not re-
place them yourself. They may be replaced only by a trained, authorised expert.
• Do not expose the SensoWash
®
D-Code directly to water.
• Do not use the product if it is not working properly.
Disconnect it from the mains immediately.
Close the water cut-off valve to interrupt the water supply. Contact your plumber/
electrician or the Duravit customer service.