DURAVIT SensoWash i - Remote Control Button Functions; Status LED Indicator Meanings; Initial Setup Procedure

44
5.1 Buttons and their functions
> Press the respective button on the remote control to switch on a function.
The button lights up white briefly.
> Press the „Stop“ button
9
on the remote control, to switch off a shower or warm
air dryer function.
5.2 Status LEDs
Red illuminated: SensoWash
®
is in the „Standby mode“, all functions cannot
be used.
Green illuminated: SensoWash
®
is in the „On mode“, all functions can be used,
„Timed energy saving mode“ is off.
Orange illuminated: All functions can be used, „Timed energy saving mode“ is on.
Flashing: Malfunction. Disconnect main power supply and contact
Duravit customer service hotline.
6. Initial operation
Remote control
> Push up and pull the battery compartment open.
> Insert three alkaline batteries (AAA) in the right polarity.
Power supply
> Connect the main power supply.
SensoWash
®
will start a self-check for about 15 seconds when it is connected to the
power supply. During this time, only the “Power” button on the seat unit can work, all
other operations will not work.
Switch SensoWash
®
on
Requirement: SensoWash
®
is in the „Standby mode“, the status display is red illuminated.
> Press the „Power“ button
I
on the seat unit.
SensoWash
®
is now switched on.
The
status display
J
is green illuminated.
All functions can now be used.
EN