DURAVIT SensoWash i - Remote Control Cleaning; Handling Prolonged Disuse; Water Filter Maintenance

55
8.4 Remote control
> Clean the remote control with a soft, damp cloth.
8.5 Prolonged disuse
If you do not use SensoWash
®
for two weeks or above, drain the water inside the product.
> Disconnect the water supply.
> Press the „Full flush“ button
6
on the remote control.
> Switch off the power supply.
> Remove the batteries from the remote control.
CAUTION
Skin irritation!
> Use the self-cleaning of the spray wand to re-circulated the water.
NOTICE
Product damage due to freezing water!
> Drain the water inside the product.
8.6 Water filter
NOTICE
Product damage due to wrong cleaning!
> Do NOT use detergent.
> Do NOT use excessive force.
> Do NOT distort the O-rings.
> DO NOT use screw drivers to dismantle and assemble the water filter.
Clean the water filter regularly or when the water flow becomes smaller than usual.
> Dismantle right side panel according to the figure below.
1
2
Fig.: Dismantle side panels
EN