DURAVIT SensoWash i - Page 60

60
Integrated flushing system
SensoWash
®
does not
flush.
The time between two
flushes is too short.
This is normal.
The water tank must be
refilled. This takes approx. 25
seconds.
The stop valve is closed .
Open the stop valve.
> Remove right side panel.
> Open stop valve.
> Install right side panel.
Power or water supply
failure.
> Pour a bucket of water (8l)
into the toilet.
> Add more water if the water
level is too low.
„Auto flush“ is not
working.
„Auto flush“ is deacti-
vated.
> Activated „Auto flush“. 7.6
Place around seat sen-
sor is dirty or wet.
> Clean the surface
The user was not seated
during the use of the
toilet.
This is normal. „Auto flush“ is
only working when the user
is seated.
> Sit on the seat for more
than 6 seconds.
The user set less than 6
seconds on the seat.
This is normal.
> Sit on the seat for more
than 6 seconds.
Night light function
The night light does
not come on.
The night light has been
set to „Off“ mode.
This is normal.
> Set the night light to „Auto“
or „On“ mode.
7.7
The night light is in
"Auto“ mode and the
ambient light is bright.
This is normal.
Problem Potential cause Solution Ch.
EN