5.5 Checking the nominal voltage and making the mains connection
The adaptation to the local mains voltage has to be done by
connecting correctly the cables at the element 2 of the main switch 1.
–
Pull out the mains plug.
–
Loosen the screw in the switching knob and remove the cover
(step 2-5).
–
Check the arrangement of the connections at the element, if
necessary reconnect it proprely according to the existing mains
voltage (see the interconnection-diagram sheet 1 or the following
diagrams).
–
Remount the cover and tighten it.
–
Connect the mains plug again.
12
21
To Next Page
Loading...
