Dux 26ECB5N - Customizable Settings; Muting the Remote Controller; Bath Fill Function

Owner’s Guide
15
Customizable Settings
Muting the Remote Controller
The Remote Controller will
emit a sound when any button
is pressed. This sound can be
muted if needed.
1. Press and hold the
Operation button for 5
seconds.
Operation
Bath Fill Function
When the bath has reached the volume set on the controller, an alarm
sounds and the hot water supply will stop automatically.
5. Turn on hot water.
6. Turn off the hot water when
the alarm sounds.
• The bath fill and the call
function alarm cannot be
muted.
• When the bath fills with
the preset volume of
water, the water will stop
and an alarm will sound.
(Default setting = Sound ON)
1.
The Operation button is ON.
3. Set the temperature using
the ↑/↓ buttons.
2. Press the Bath fill button.
Operation
• Check the current setting
temperature.
• The bath fill temperature
will flash. After 10
seconds, it will be
displayed.
• The bath fill volume
setting will flash.
* Bath fill volume options
may change depending
on the continuous flow
models.
•
The level can only be
adjusted while the bath fill
volume setting is flashing.
• After 10 seconds, the
Remote Controller
will again display the
temperature.
• (For Bathroom controller)
To alter the bath fill
volume press the Priority
button after the Bath fill
button.
• When using hot water at
another hot water outlet,
also turn it off.
• [When you turn off the
hot water supply]
Bath fill temperature
indicator turns off. (within
approx. 1 minute)
• [If you do not turn off the
hot water supply]
The equipment
automatically runs the
water to check if the hot
water supply has been
turned off.
• [When approx. 10
minutes passes without
turning off the hot water
supply the sound is
played]
The screen “oFF” appears,
so turn off all the hot
water supplies and then
press the Bath fill button.
• The setting temperature
becomes the bath fill
temperature after the
bath fill was used.
• Button operation may not
be accepted at the end of
bath fill.
4. Press the Set volume
button, and adjust with the
↑/↓ buttons.
(Default setting = 160 L)
40 - 80 L (In 20 L intervals),
120 - 200 L (In 40 L intervals),
250 - 650 L (In 50 L intervals)
[Muted]
No sound after 5 seconds
[Sound ON]
Sounds after 5 seconds
SBB816U取説GQ-C2434WS DU#B.indd 15 2019/11/12 11:53:47