Owner’s Guide
21
Inlet water filter
If the inlet water filter is covered with debris, the
hot water may not run smoothly, or the Water
Heater may put out cold water. Check and clean the
filter as explained below.
1. Close the water supply valve.
NOTE
Do not lose the Sealing.
2. Open all hot water fixtures.
3. With a bucket ready, remove the inlet water
filter. (about 1 L will drain out)
4. Clean the inlet water filter with a brush under
running water.
5. Reattach and close inlet water filter.
6. Close all hot water fixtures.
7. Open the water supply valve and check that
water does not leak from the inlet water filter.
(e.g. 26ECB5N)
To prevent burns or scalding, turn off the
Operation button and wait until the appliance
cools before draining the water.
WARNING
Sealing
Inlet water filter
Water Supply Valve
SBB816U取説GQ-C2434WS DU#B.indd 21 2019/11/12 11:53:48
To Next Page
Loading...
