G2030-II-S
Apr ‘19
- 18
‘CSC300’ Controller (cont’d)
Access Code Entry.
To gain entry to areas of the Controller in which an Access Code is required:
Adjusting the parameters of the Controller could adversely affect the operation of the Unit. Only those
individuals with knowledge of the Unit should be permitted to make any adjustments.
3. The screen shown below will appear
1. When navigation location is at P00
4. Press ‘Enter’ key to navigate into P09
menu content and press ‘Down’ key to
highlight P09.04 Service 1.
5. The screen shown below will appear
6. Press ‘Enter’ key
2. Press the ‘Down’ key to navigate to P09
Access page.
To Next Page
Loading...
