- 39 -
4. Place one 5/16” External Star Washer on each of the four bolts that are installed in the tuner shelf
bracket and then place the MFJ-998RT Tuner on the bolts as shown. Position the tuner so it is
straight and the large hole on the tuner metal bracket is close to the antenna (this is where the
feedline wire will pass through). Use one 1/4”-20 Acorn Nut on each of the bolts to secure the
MFJ-998RT tuner in place.
5. When the upper antenna parts are mounted to the base assembly (see previous installation
instructions), install the Studded Band Clamp on the first element just above the black insulator
with the stud facing the side nearest the tuner connections. Install the 10” long tuner wire from
the studded band clamp using the #10 hardware. The other end of the 10” wire is connected to
the tuner output wing nut connection as shown.
To Next Page
Loading...
