Dyna-Glo DGO1176BDC-D - Page 7

7
ASSEMBLY INSTRUCTIONS
3. CAUTION: This unit is HEAVY! Do not attempt
this step without assistance!
With the assistance of a helper, stand the unit up
right on its legs on a rm and level surface. (Make
sure that legs are well attached). Place both doors
back onto the smoker body. Position the square
smoke stack (A) with control arm to the left as
shown. Using 4 bolts (AA), attach square smoke
stack (A) to the top of smoker body (G). Securely
tighten with a Phillips screwdriver.
4. Attach lifting handle (B) to smoker body-left (G)
using four M6x12 screws (AA).
5. Attach door handle bracket (K) to smoker
body-left (G) using two M6x12 screws (AA).
K
AA
G
G
B
A
G
AA
AA
3
4
5
Hardware Used
AA
M6 x 12mm
Screw
x 4
Hardware Used
AA
M6 x 12mm
Screw
x 4
Hardware Used
AA
M6 x 12mm
Screw
x 2