Dyna-Glo DGO1176BDC-D - Page 8

8
ASSEMBLY INSTRUCTIONS
6. Slide door handle (D) through brackets in door.
Using pliers, slide a spring clip (BB) over the
groove in the door handle as shown. Make sure
the spring clip is securely attached in the
grooves of the handle.
7. First, remove the pre-assembled nut from the
temperature gauge. Insert the probe of the
temperature gauge (C) through hole of the
smoker door from the outside. Secure with nut
from inside panel. Tighten with wrench.
G
C
7
Hardware Used
BB
Spring
Clip
x 1
D
G
BB
6