Dyna-Glo Pro - All Models; Unpacking Heater

 6
PROPANE CONSTRUCTION HEATER
UNPACKING HEATER
1. Remove heater from carton.



damage, promptly inform dealer/distributor where you purchased heater.
Assembly Components and Instructions for Steel Base Units:
1. Assembling the Cord Wrap Attachments:
(FA100 - FA150 Series Only)
Parts Required:

and 2 Cord Wrap Attachments
Place the cord wrap attachment
as shown, then use Phillips
screwdriver to tighten the
screws and secure the
cord wrap attachments.
2. Regulator and Hose Connection:
(All Models)

Connect the hose tightly to
the heater using a wrench.
Please also refer to
page 8 in the manual.

use a wrench
Hose Assembly
Assembly Time:

Contents:
All Models: Unit, Manual, Hose and Regulator
Assembly
FA100 - FA150 Series Includes:

Tools required for assembly:
All Models: Adjustable Wrench
FA100 - FA150: Phillips Head
Screw Driver
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!