Dyna-Glo Pro - Information on Propane Gas Cylinders

7 8
PROPANE CONSTRUCTION HEATER
INFORMATION ON SIZE * CAPACITY OF PROPANE GAS CYLINDERS:




The propane (LP) gas tank must also be equipped with the following:


American National Standards for Compressed Gas Cylinder Valve Outlets and Inlet
Connections.


The propane (LP) gas pressure regulator and hose assembly supplied with
this heater must be used without alteration.
The hose assembly shall be visually inspected prior to each use of the heater. If it is evident
that there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the

by the manufacturer.

Temperature

40,000-60,000 BTU/h
100,000 -


1 - 20lb 2 - 100lb 2 - 100lb
1 - 20lb 2 - 100lb 2 - 100lb
1 - 20lb 2 - 100lb 3 - 100lb
1 - 20lb 3 - 100lb 3 - 100lb
2 - 20lb  
1 - 100lb  
Above 32°F
32°F
20°F
10°F
-10°F
-20°F
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!