Assembly Components and Instructions for Plastic Base Units:
6
PROPANE CONSTRUCTION HEATER
Hose Assembly
1. Assemble the Leg:
Parts Required: Adjustable Leg
Place the heater as shown,
insert the leg into holes of
the base, then adjust
to the desired height.
4. Regulator and Hose Connection:
Connect the hose tightly to
the heater using a wrench.
Please also refer to
page 8 in the manual.
3. Assembling the Cord Wrap Attachments:
Parts Required:
and 2 Cord Wrap Attachments
Place the cord wrap attachments
as shown, then use Phillips
screwdriver to tighten the screws
and secure the cord wrap attachments.
2. Assemble the Height Control Screw:
Parts Required: Height Control Screw 2 pcs
Turn the Height Control Screw
Height Control Screw counter-
use a wrench
Assembly Time:
Contents:
All Models: Unit, Manual, Hose and Regulator
Assembly, Adjustable Leg, 2 Height Control Screws
FA125 Series Includes:
Tools required for assembly:
All Models: Adjustable Wrench
FA125 Series: Phillips Head
Screw Driver
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
To Next Page
Loading...
