Dynamic RHINO2 DS120 User Manual

GBK51948 RHINO2
Installation Manual Issue 5
6.5.3.11 Emergency Deceleration
Parameter Possible Values Default HHP Lite Std Adv
Emergency Deceleration 0 - 100 % 80 %
✓
Emergency Deceleration sets how quickly the scooter comes to a halt when travelling
forward and:
l
a Stop input is active, or
l
a fault that requires an emergency stop occurs, or
l
the key switch is removed while driving forward.
Note that Emergency Deceleration applies only to the forward direction; when decelerating
in reverse, normal deceleration applies. Compare this with Slam Braking, which is applied
in both directions, forward and reverse.
If the normal deceleration rate is higher than Emergency Deceleration, the normal
deceleration value is used.
Warning
If this parameter is set too high, the user can fall out of the scooter during an emergency stop.
Warning
Soft Start Period and Soft Finish values have the potential to impact the Emergency Deceleration rate.
Manufacturers should consider the impact of these values when setting the Emergency Deceleration rate to
ensure that required stopping distances can be achieved. It is recommended to set Soft Start Period and Soft
Finish values before finalising the Emergency Deceleration value.
6.5.3.12 Slam Braking
Parameter Possible Values Default HHP Lite Std Adv
Slam Braking 0 - 100 % 50 %
✓
Slam Braking sets how quickly the scooter comes to a halt when the throttle is moved
significantly in the opposite direction to the direction that the scooter is currently moving in.
Slam Braking is enabled with Slam Brake Enable and its threshold, which is the minimum
amount of throttle movement in the opposite direction before slam braking is engaged, is
set with Slam Brake Threshold.
Note that if the normal deceleration rate is higher than Slam Braking, then the normal
deceleration value is used instead of this setting.
Warning
If this parameter is set too high, the user can fall out of the scooter during a slam braking operation.
6.5.3.13 Push Speed
Parameter Possible Values Default HHP Lite Std Adv
Push Speed 5 - 70 % 15 %
✓
This feature will limit the scooter to a safe speed when:
Page 88 - Programming

Dynamic RHINO2 DS120 Specifications

General

Brand	Dynamic
Model	RHINO2 DS120
Category	Controller
Language	English