Dynapac CP2700 - Weekly Maintenance Tasks (50 Hours); First 50 Hours Maintenance; Routine 50 Hours Maintenance

Scheduled maintenance and lubrication
2018-02-19 4812325557EN 71
WEEKLY (after the first 50 hours of operation)
POSITION
IN THE
FIGURE
ACTION
NOTES
1, 2
Replace the Diesel engine oil and
the oil filter
Refer to the engine
manual instructions.
10
Check and replace the main air
filter
Refer to the engine
manual instructions.
10
Check and replace the secondary
air filter
Refer to the engine
manual instructions.
3
Replace the engine fuel filter
Refer to the engine
manual instructions.
4
Replace the hydraulic oil filters
20
Lubricate the lower pivot bearing
21
Lubricate the upper pivot bearing
23
Replace the wheel gear oil
WEEKLY (Every 50 hours of operation)
POSITION
IN THE
FIGURE
ACTION
NOTES
-
Check the engine air intake system
Refer to the engine
manual instructions.
-
Check the tires air pressure
-
Retighten the wheel nuts
10
Check and clean the engine air
filter elements
Replace them, if
necessary
-
Drain the fuel pre-filter
Refer to the engine
manual instructions.
18
Check the air conditioning
When equipped (option)
-
Clean the air conditioning
19
Check and lubricate the edge cutter
When equipped (option)
20
Lubricate the lower pivot bearing
21
Lubricate the upper pivot bearing