Dynapac CP2700 - Scheduled Maintenance Procedures; Daily Maintenance Tasks (10 Hours)

Scheduled maintenance and lubrication
70 4812325557EN 2018-02-19
Scheduled maintenance and lubrication
Maintenance and lubrication procedures
The maintenance and lubrication shall be carried out first based
on the working hours. When they cannot be considered, use the
periods, like daily, weekly, etc.
Always clean around the covers, plugs, grease
nipples or hoods before open or apply grease to
them.
Respect and follow the engine manufacturer
instructions. For further information, refer to the
Engine Manual.
DAILY (Every 10 hours of operation)
POSITION
IN THE
FIGURE
ACTION
NOTES
Before starting the engine
1
Check the Diesel engine oil level
Refer to the engine
manual instructions.
9
Check engine coolant level
5
Check the hydraulic oil level
11
Fill the fuel tank
13
Fill the water tanks
14
Check the sprinkler system
14
Clean the sprinkler injector
12
Adjust the scrapers
-
Check the brakes oil level
-
Clean the pre-filter
-
Check the alternator belt tension
Refer to the engine
manual instructions.
-
Drain the fuel filter
Refer to the engine
manual instructions.