Dynapac CP2700 - Every 1000 Hours Maintenance - Wheel Gear Oil; Replacing Wheel Gear Oil

Maintenance - Every 500 hours
92 4812325557EN 2018-02-19
Lubricate the upper/lower pivot bearing
1. Lubricate the grease fitting of the upper pivot bearing (1)
and the grease fitting of the lower pivot bearing (2)
operating the grease gun manually with five pump strokes.
2. Use the grease according to the lubricant specifications
recommended by DYNAPAC.
Lubricate the pivot bearing
1. Lubricate each grease fitting (1) with five hand-operated
strokes.
2. Use the grease according to the lubricant specifications
recommended by DYNAPAC.
Replace the air dryer filter
To replace the filter, empty the compressed air and unscrew the
cartridge with suitable tool.
Clean and grease the sealing surfaces and the fixing screw.
Manually screw the cartridge until there is resistance, and
tighten half turn.
Fig. – Air dryer filter
1. Cartridge
1
Fig. - Rear cylinder
1. Grease fittings
1
2
Fig. - Pivot bearings
1. Upper pivot bearing grease fitting
2. Lower pivot bearing grease fitting
1