Handheld Pulse Oximeter (Reorder No. 36403) 9
1. INTRODUCTION (Continued)
• Unplug the sensor from the oximeter before cleaning or
disinfecting it. If liquid is accidentally spilled on the unit,
clean and dry thoroughly before reuse.
• Do not try to use the SpO
2
and NIBP measurement on the
same arm at the same time. This could potentially affect
measurement accuracy.
• At the end of its service life, the equipment must be
disposed of in compliance with the guidelines regulating
the disposal of such products. If you have any questions
concerning disposal of the equipment, please contact your
distributor.
• Always install and carry the equipment properly to avoid
damage caused by drop, impact, strong vibration or other
mechanical force.
NOTES
• Put the equipment in a location where you can easily see
the screen and access the operating controls.
• Keep this manual in the vicinity of the equipment so that it
can be easily obtained when needed.
• The software was developed with compliance to
IEC60601-1-4 to minimize the possibility of software
errors.
• SpO
2
measurements may be inuenced by high ambient
light, especially sunlight. Shield the sensor area if
necessary.
• Dyes introduced into the bloodstream, such as methylene
blue, indocyanine green, indigo carmine, and uorescein,
may inuence the accuracy of the SpO
2
reading.
To Next Page
Loading...
Need help?
General
