Previous, Play/Pause, Next
Use these buttons to plays or pause the selected track and select the previous or next track.
Note
Play/pause next and previous functions do not operate with WiSA or wired audio sources.
Input Selection
Use these buttons to select the Digital optical, Digital coaxial, WiSA, Analogue line and Bluetooth inputs.
Note
Network streamed audio has priority over Bluetooth, wired and WiSA inputs.
Internet Radio Presets
Use this button to select Internet radio station presets.
Note
Three favourites can be stored as presets via the Dynaudio Set-up and Control app.
Volume down • Mute/Un-mute • Volume up
Use these buttons to control volume and mute/unmute the speakers.
The remote control incorporates two hidden “housekeeping” functions:
Bluetooth Pairing Mode
To switch Focus speakers to Bluetooth pairing mode, press and hold the Bluetooth button on the remote control
for three seconds.
Resetting the Remote Control
▪ To reset the remote control, press and hold the preset 1 and 3 buttons until the remote control indicator flash green. Now
press and hold the Primary speaker rear panel Bluetooth button (A-2) for three seconds to initiate pairing mode.
The remote control will restart and reconnect to the speakers. The remote control indicator will flash while pairing is
underway. The speakers will play a confirmation sound when pairing is complete.
Pairing a Replacement Focus Remote Control With Your Speakers
1. Insert the battery into the remote control.
2. While the remote control’s LED is flashing green, press and hold the Primary speaker rear panel Bluetooth button (A-2) for
three seconds.
After a short time, the remote control and the speakers will be paired. The speakers will play a confirmation sound when
pairing is complete.
Using and Controlling Your Focus Speakers 29
To Next Page
Loading...
