USB Setup
PC and Daisy Instructions
LMI’s with USB ports will need the COM Port that is automatically assigned by a PC,
when an USB device is plugged in to it, set to match a COM Port in the Daisy
configuration file. This can be done through the PC as follows:
Daisy Software Start-Up
Verify USB port assigned to LMI:
1) Power-up LMI with USB connected to PC
2) On PC, go to Control Panel/System/Hardware/Device Manager/Ports(Com
and LPT)
3) Note Comm port of “ATEN USB to Serial Bridge”
4) Go to PC and open (with WordPad or NotePad) C:\ “Device1.cfg”
Series 4000 Melt Indexer Operation Manual USB Setup
74
To Next Page
Loading...
