providing a window into the process
Auto H
old
Enable to let lift bucket lower until its weight-holding edge is 3.88” off top of barrel. This allows
the weights to push the piston to the “First Scribe” mark and no further during the melt time of
the test.
• Bucket may be lower than weights during hold if there is a lot of material in barrel
causing the pistons and weights to sit higher.
• Hold is useful for high-flow materials and can be used in conjunction with a melt plug.
The hold keeps the weights from extruding the melted sample before the melt time has
expired.
After setting lift options, press
to get to button and save in test procedures or
recipes.
P/N: M0726(3) | Rev: 012020 | ECO: 51182
www.dynisco.com
To Next Page
Loading...
