8
5
Fig.F
Stock connectors
PCIIIr connectors
Trouble Shooting
If you feel that you are having any problems at all with the Power
Commander III, disconnect it from your motorcycle. This will allow
the motorcycle to run directly off of the stock ECU.
The lights don’t come on when I turn the ignition switch on.
Check to make sure connectors are seated and the kill switch is in
the “run” position.
The on-board adjustment buttons do not hold their settings.
Be sure to wait 20-30 seconds after making adjustments before
starting or turning off the bike.
Can not upload to or download from the Power Commander III.
Check to see that the serial cable is firmly in place. Verify that
ignition switch is on and the kill switch is in the “run” position.
My mouse uses the same serial port.
If your computer has a PS/2 port purchase a DB9 to PS/2 adapter for
your mouse.
I get a “verify failed....” message when I upload a map to the
Power Commander III.
Programs running in the background or fluctuations in supply voltage
(from outlet) can sometimes cause this error. In most cases, the
information was sent properly to the Power Commander III. Pushing
the “upload all” button again should produce a “tables sent and
verified” message.
I typed in notes, but they didn’t save.
You need to first push the “accept” button in the notes window and
then the “save file” button.
Fig.E
Unplug the black
connector with the
blue and green wires
To Next Page
Loading...
Need help?
General
