Fitting notes
Service manual
18
38 Attach the new switch to the wires.
Wrap the previously removed
length of glass cloth tape around
the terminals ensuring they are fully
covered.
Note: if the glass cloth tape is
unusable it will be necessary to cut
a length approximately 60mm off
a roll.
Position the switch onto the chassis
ensuring the terminal boots sit
behind the wall section.
Neatly dress the switch wires into
the channel provided.
39 Slide the actuator housing onto
the chassis until it ‘clicks’ into
position.
40 Fit the two T-15 screws.
Switch - fitting
To Next Page
Loading...
