Dyson DC26 Service Manual

Fitting notes
Service manual
28
62 Remove the two Torx T-8 screws
from the the bleed valve housing.
63 Carefully ease the bleed valve
housing out of the chassis using a
thin flat bladed screwdriver.
61 Remove the screw in the stow
bracket.
Carefully prise one side of the
stow bracket away from the
chassis to release it. Repeat on the
other side.
The following components are only offered separately and will require removing from
the chassis and motor assembly, before fitting to the new assembly.

Dyson DC26 Specifications

General

Suction power	160 AW
Maximum input power	- W
Annual energy consumption	- kWh
Proper use	Home
Noise level	- dB
Removable filter	Yes
Cleaning surfaces	Carpet, Hard floor
Vacuum air filtering	HEPA
Dirt separating method	Filtering
Type	Cylinder vacuum
Cordless	No
Cleaning type	Dry
Dust capacity	- L
Product color	Blue, Transparent
Tube material	The material the tube is made of.
Dust container type	Bagless
Cord length	5 m
Dust capacity dry	0.68 L
Vacuum brushes included	Hard floor brush

Weight and Dimensions

Weight	5200 g