PG300/302 Owner’s Manual
17
REPLACE/ADD COLLAR
Occassionally, it is necessary to pair/sync a transmitter to a collar
receiver, the following procedure will accomplish this:
1. Turn on the Transmitter
2. Turn intensity dial to “0”
3. Make sure the collar receiver is turned off.
4. Put the Transmitter’s Red Dot against the Collar Receiver’s Red Dot
for more than 5 seconds, green light on Receiver will flash rapidly
5. Immediately after, press and hold Black “S” Button followed by the Red
“S” Button until you hear confirmation sound from Collar Receiver.
HOW TO CHANGE THE TRANSMITTER TO A 2 DOG TRANSMITTER
The button functions will change. The changes are described on pages 18
through 22. You can change the transmitter back to the 1 Dog system
(PG 300) at any time.
1. Turn on the Transmitter.
2. Press the Red "S" followed by the Black "S" followed by the "T" Button
simultaneously for more than 2 seconds until you hear the confirmation beeps.
3. Repeat step 2 to return back to a 1 dog system.
ADD/REPLACE COLLAR FOR SECOND DOG
1. Turn on the Transmitter
2. Turn intensity dial to “0”
3. Make sure Receiver is turned off.
4. Put the Transmitter’s Red Dot against the Collar Receiver’s Red Dot
for more than 5 seconds, green light on Receiver will flash rapidly.
5. Immediately after, press and hold Red "S" Button followed by the Black
"S" Button until you hear confirmation sound from Collar Receiver.
To Next Page
Loading...
