PG300/302 Owner’s Manual
22
302 BOOST LEVEL SETUP
Boosted vibration adds the set boost level to the vibration level,
great for those situations when your dog does not respond to the
“conditioning” level. Determining the Boosted vibration level is a little
more difficult than vibration level setting due to the wide differences
in temperaments and vibration tolerance among the many breeds
of dogs. On average, it is normally 5 to 20 levels higher than the
“conditioning” level. It is important to have it set high enough to get
the desired response from your dog.
How to Setup Boost Level for First Dog
1. Change the mode to Momentary Mode
(Press M/C button until “M” is displayed)
2. Change the intensity level to “0”
3. Press S(Black) button for more than 5 seconds
4. The intensity level will change 0 to 1 and start to blink.
5. Rotate the dial to change the boost level (up to 60).
6. Press S(Black) button again to save and exit from Boost Level
Change Mode. If any other button is pressed or idle for 20 sec,
Boost Level Change Mode will be cancelled.
If you want to change boost level for dog 2, Press
S(Red) instead of S(black) on steps 3 and 6
To Next Page
Loading...
